GForce Engineering fully-fabricated 9” IRS With modified cradle

[Linda's Hell Cat]

I’m not sure of the “proper” procedure for aligning the cradle when reinstalling but I hung a plumb bob from each side of the car and measured to the centre of the axel stub then also measured from the centre of the axel stub forward to the same point on the car on both sides.
I managed to get the cradle cantered both side to side and front to back within 1/16” or 1/32” per side so that should be good enough and I will be getting an alignment done anyways in the spring.

Even though you are past this, but I thought that it might help for anyone doing this to read the BMR directions for installing a cradle lockout kit.
It's good these days when the MFG has install instructions for their parts.


chrome-extension://efaidnbmnnnibpcajpcglclefindmkaj/https://www.bmrsuspension.com/siteart/install/CB005.pdf

Everything is looking good!

 

[Ta2ude]

My fuel clip showed up today from Aliexpress and it didn’t match the photo on their site and did not work, I guess I will find out how good the return/refund system works there.